FishingTN.com Tennessee's Fishing and Boating Community

FishingTN.com Tennessee's Fishing and Boating Community (http://www.fishingtn.com/index.php)

- Sports Lounge - General (http://www.fishingtn.com/forumdisplay.php?f=15)

- - Depth finder help (http://www.fishingtn.com/showthread.php?t=5962)

Jdkxtreme

11-24-2012 07:53 PM

Depth finder help

I recently installed a lowrance elite 4 on my boat. The transducer is mounted 3" from the drain plug on the port side. As low as I could put it. When I am at speed it says I am in 1.2 - 1.5 foot of water. I have not contacted lowrance yet. The guy at bass pro said it was coming out of the water. Is that possible at 23MPH?

tkwalker

11-24-2012 08:58 PM

Transducer set up <'TK><

Quote:

Originally Posted by Jdkxtreme (Post 26846)

JD do you have the transducer pickup surface parallel with the bottom of your boat ... Take a straight edge and place it on the bottom of the boat ... adjust the pickup so it is at the same surface ( even with the straight edge ... <'TK><

Jdkxtreme

11-24-2012 09:24 PM

Quote:

Originally Posted by tkwalker (Post 26847)

It's is parallel

tkwalker

11-24-2012 10:03 PM

maybe this is your problem <'TK><

All transducers are usually mounted on the starboard side of the boat ,, Even though the motor torque has a tendancey to lift the Starboard side (depends on size of motor and boat) ... But do to the fact that the driver sits on the starboard size there is a good possability that the boat is listing enough to the right and raising the left side to have an air gap between the Pickup and the surface ... <'TK><

Jdkxtreme

11-24-2012 10:13 PM

I will move it before I go back out. I just put it where it is because it looks like one used to be there. Think it will be ok to put next to the factory speedo thing?

All times are GMT -5. The time now is 06:37 PM.